We have put together some simple instructions below to help you get your bed setup.
It is a straight forward process that should take 15-20 minutes, just follow the instructions below and you will have it up in no time.
Step 1 – Preparation
Before you begin, please ensure you have enough space to move around.
Unpack all the items including the headboard and bases and place them on the floor.
Step 2 – Check Supplied Parts
- 8 Mushroom Feet
- 5 Screws
- 2 U Clips
Ensure you have all the items listed above.
Step 3 – Attach Mushroom Feet
Attach mushroom feet as shown, they are a tight fit so may need a little encouragement to go in.
Step 4 – Connect the Gas Lift Struts
Use the attached screws to hold the gas struts in place, please ensure these are screwed in tightly as they do all the heavy lifting.
Step 5 – Attach the U Clips to the Bases
Place the bases flat on the floor and bring them together with the correct bases on each side, the bases are normally labelled left and right on the packaging.
Attach the U Clips at the bottom and top of the bases.
Step 6 – Prepare the Base Fabric
Using the screws supplied make holes in the fabric.
This step will make it easier for you to screw the floor standing headboard to the bases.
Step 7 – Connect the Head to the Bases
Place the head next to the bases and screw the head into the bases.
Step 8 – Connect the lids together
On the left hand side lid use the supplied screw to make the hole. Screw the lids together.
Step 9 – Place the Mattress
With the bases open place the mattress on top. The weight of the mattress will make the lids go down with a little push.